Candy Corn Shaker Card Assembly

Supplies

Don’t have this design yet? Get it on Etsy or the Silhouette Design Store.

• White cardstock (if using textured cardstock, you will also need smooth white cardstock for the inside of the card)

• Yellow cardstock

• Orange cardstock

• Clear acetate

  • Buy Bearly Arts Clearly Craft Plastic on Amazon

• Glue

  • Buy Bearly Arts Craft Glue on Amazon

• Double-sided foam tape (1/4 inch tall recommended)

  • Buy Bearly Arts Cubbies on Amazon

• Shaker filler

  • Buy Buttons Galore filler on Amazon

  • Buy assorted jelly rhinestones on Amazon

I used Encore textured cardstock from 12×12 Cardstock Shop for this card in the following colors:

• Snowy White

• Goldfish

• Golden Amber

I used the Encore smooth cardstock in Snowy White for the message panel inside the card.

For the shaker filler, I used mix of Buttons Galore Doo Dads in Marmalade and Sprinkletz in Tri-Color Treats.

Assembly Steps

1. Attach white message panel inside the card. Fold and crease the card base.

2. Attach the white and yellow triangles to the front of the card to make the candy corn pattern.

3. Glue the acetate to the inside of the orange frame. Make sure to remove any protective layers on your acetate before gluing.

4. Attach the white and yellow front frame pieces to the front of the frame.

5. Line the entire inside (acetate side) edge of the frame with double-sided foam tape, being careful not to leave any gaps. Do not remove the protective layer from the top of the foam yet! Fill your frame with shaker bits. Then gently peel the protective layer off the foam tape. Carefully place the card face down over the frame and press to adhere to the foam tape.

6. Shake your card!

---

Some links in this post may be affiliate links. This means I may earn a small commission at no extra cost to you. I only share tools I genuinely use and love.