3D Bow Assembly

Supplies

• Cardstock color of your choice

• Glue (tape runner or tape dots are not recommended)

Assembly Steps

1. Take the larger piece of the blow (looks a bit like a bow tie), and glue the tabs on each end to the area in the center. Don’t crease the loops created on the sides of the bow.

   Hold this piece for a few seconds to let the glue dry.

2. Repeat step 1 for the smaller piece of the bow.

3. Glue the smaller bow on top of the larger bow and hold in place for a few seconds to the let the glue dry.

4. Glue the stacked bows on top of the long piece with a V-shape on the ends. This makes the ends of ribbon on the bow. Hold these pieces together for a few seconds to allow the glue to dry.

5. Wrap the small rectangle around the center of the bow. Glue one end the back of the bow and then wrap the piece over the font and then glue the other end. Pinch the whole bow together in the center for a few seconds to allow the glue to dry.